controls stop working when i screw the GB case shut

Post Reply
Maniac-Uk
Posts: 6
Joined: Thu Jun 15, 2017 2:57 am
Been thanked: 1 time

controls stop working when i screw the GB case shut

Post by Maniac-Uk » Mon Jul 16, 2018 7:23 am

work fine till I screw in the screws to close the case up cannot see any shorts or where it might be touching?

what area should I apply the tape just in case I am missing something

Maniac-Uk
Posts: 6
Joined: Thu Jun 15, 2017 2:57 am
Been thanked: 1 time

Re: controls stop working when i screw the GB case shut

Post by Maniac-Uk » Tue Jul 17, 2018 3:15 am

will take some images later but wifi mod defently coverd same with mode switch will put some tape on c connection.

see how that goes.

Maniac-Uk
Posts: 6
Joined: Thu Jun 15, 2017 2:57 am
Been thanked: 1 time

Re: controls stop working when i screw the GB case shut

Post by Maniac-Uk » Thu Jul 19, 2018 2:17 am

Fixed was the C USB connector doing it. the strange thing is now the wifi has stopped working now. just show think it G in wifi list. there is no router called G in my area just brought it in to the office to test it there and the same thing.

Maniac-Uk
Posts: 6
Joined: Thu Jun 15, 2017 2:57 am
Been thanked: 1 time

Re: controls stop working when i screw the GB case shut

Post by Maniac-Uk » Thu Jul 19, 2018 4:03 am

Ok, will go through the list might crack it open again as well see if that solves the issue.

just out of interest if I was to install a c USB ethernet cable would it work? as just looking for a way to dump a large collection of roms.

as USB method froze on me and now won't resume uploading roms.

Maniac-Uk
Posts: 6
Joined: Thu Jun 15, 2017 2:57 am
Been thanked: 1 time

Re: controls stop working when i screw the GB case shut

Post by Maniac-Uk » Mon Jul 23, 2018 7:03 am

ok sorry for the delay the joys of having a 9month old takes a lot of my time

Fixed it think I was having a blonde moment lack of sleep had switched off the wifi with mod switch all working just adding the few emulators for my set up and done thanks for the help.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest