New CS Build - No WiFi or Mode Functions...
Posted: Fri Oct 12, 2018 10:48 am
Hi all,
I have a brand new Circuit Sword I just built and I am unable to get wifi to work. I am also unable to use the mode button for alternate functions.
I have checked all of my wiring. Everything else is fine. I have 2 layers of kapton tape over the mode switch pins and another layer on the USB-C jack itself (wrapped around it's exterior). I did a continuity test on the power cable connector for the mode button to ensure I soldered it in correctly and that the tact switch itself was functional. I did eventually lockup the Pi and was able to flip the power off (it didn't gracefully shutdown since it locked up) and use the mode button to insta-kill power. So I know the button is functional. I have also tried using the mode functions with the two halves split to no avail. I also ran the update.sh and the cs-tester from the Circuit Sword directory and they did not help either.
Any ideas on what could cause my 2 issues (wifi & mode functions)?
Thanks in advance for any help
P.S. I did perform the electronics sanity check before my build and with the shell open after my build. All mainboard LEDs operate as expected.
I have a brand new Circuit Sword I just built and I am unable to get wifi to work. I am also unable to use the mode button for alternate functions.
I have checked all of my wiring. Everything else is fine. I have 2 layers of kapton tape over the mode switch pins and another layer on the USB-C jack itself (wrapped around it's exterior). I did a continuity test on the power cable connector for the mode button to ensure I soldered it in correctly and that the tact switch itself was functional. I did eventually lockup the Pi and was able to flip the power off (it didn't gracefully shutdown since it locked up) and use the mode button to insta-kill power. So I know the button is functional. I have also tried using the mode functions with the two halves split to no avail. I also ran the update.sh and the cs-tester from the Circuit Sword directory and they did not help either.
Any ideas on what could cause my 2 issues (wifi & mode functions)?
Thanks in advance for any help
P.S. I did perform the electronics sanity check before my build and with the shell open after my build. All mainboard LEDs operate as expected.