Circuit Sword Joystick rubbing on case/sticking

Post Reply
Joeblowv1
Posts: 28
Joined: Mon Dec 24, 2018 9:24 pm
Been thanked: 2 times

Circuit Sword Joystick rubbing on case/sticking

Post by Joeblowv1 » Sat Jul 27, 2019 11:06 am

Hi all you circuit sword builders. Quick question to all of you who have mounted up a psp joystick using the 3d printed bracket here in the lower left corner of the build. (not centered with holyhoo's bracket) has anyone had any issues with the stick chaffing on the case or like otherwise sticking when pressed?

I hot glued the edges down of the bracket, not sure if thats causing some issues, but was also wondering if anyone had any input on avoiding the joystick rubbing/chaffing/pinching on the case?

Percoseth
Posts: 18
Joined: Thu Jan 11, 2018 12:10 pm
Has thanked: 6 times
Been thanked: 4 times

Re: Circuit Sword Joystick rubbing on case/sticking

Post by Percoseth » Sat Jul 27, 2019 1:53 pm

I removed the little plastic washer from the joystick because I had this problem. That fixed it. It was either that or sand a light groove into the inside of the case for me.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest