sudomod

Hi all you circuit sword builders. Quick question to all of you who have mounted up a psp joystick using the 3d printed bracket here in the lower left corner of the build. (not centered with holyhoo's bracket) has anyone had any issues with the stick chaffing on the case or like otherwise sticking when pressed?

I hot glued the edges down of the bracket, not sure if thats causing some issues, but was also wondering if anyone had any input on avoiding the joystick rubbing/chaffing/pinching on the case?

I removed the little plastic washer from the joystick because I had this problem. That fixed it. It was either that or sand a light groove into the inside of the case for me.