Circuit Sword Lite QI Charging

Post Reply
Percoseth
Posts: 18
Joined: Thu Jan 11, 2018 12:10 pm
Has thanked: 6 times
Been thanked: 4 times

Circuit Sword Lite QI Charging

Post by Percoseth » Sat Jul 27, 2019 1:47 pm

I'm looking to add a QI charger and noticed at the top of the board there are solder points labeled "chg" and "pwr". Is "chg" where I would connect it?

Percoseth
Posts: 18
Joined: Thu Jan 11, 2018 12:10 pm
Has thanked: 6 times
Been thanked: 4 times

Re: Circuit Sword Lite QI Charging

Post by Percoseth » Sun Jul 28, 2019 7:26 am

Nevermind. Those are for LEDs. I don't know what I was thinking.

User avatar
kite
Posts: 852
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 223 times
Been thanked: 286 times
Contact:

Re: Circuit Sword Lite QI Charging

Post by kite » Tue Jul 30, 2019 9:37 am

Near the USB connector, should be two solder holes labelled PWR, these are the used for 5v input for charging

Percoseth
Posts: 18
Joined: Thu Jan 11, 2018 12:10 pm
Has thanked: 6 times
Been thanked: 4 times

Re: Circuit Sword Lite QI Charging

Post by Percoseth » Wed Jul 31, 2019 9:34 am

Thanks. That's what I used.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest