Hi, I have a circuit sword lite build that I’m not getting any sound from the speaker on. I’ve attached a photo in case anybody can see anything obvious.
I hooked up the speaker from another lite I’ve built and know works - still no sound. I’m using the same Tetris rom on my working build and this one. I never use USB and the switch for USB is still off.
Edit:Circuit sword lite - no audio from speaker
- kite
- Posts: 972
- Joined: Thu May 12, 2016 4:30 am
- Location: UK
- Has thanked: 246 times
- Been thanked: 361 times
- Contact:
Re: Circuit sword lite - no audio from speaker
When run in tester mode, does the USB AUDIO test pass?
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
- kite
- Posts: 972
- Joined: Thu May 12, 2016 4:30 am
- Location: UK
- Has thanked: 246 times
- Been thanked: 361 times
- Contact:
Re: Circuit sword lite - no audio from speaker
Check the USB wire soldering (the 3pin JST wire) and check for shorted between the soldered contacts, post pictures of that area if you'd like my feedback on it
Stock clearance - CLOSED: viewtopic.php?f=38&t=12064
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Kite's Mailing List: https://goo.gl/forms/e97uUvPOfUxPWdz82
Kite's FAQ: https://kiteretro.com/faq/
Re: Circuit sword lite - no audio from speaker
You sir are a legend. A small strand of wire had bridged ground and live over the usb solders and was stuck to the inside of the kapton tape. Fresh tape and all is well!
Who is online
Users browsing this forum: No registered users and 1 guest