Mintypi v2 screen board (Helder) question

Resolved mintyPi issues go here. Search this section first before creating a new support thread!
Post Reply
User avatar
Wailer
Posts: 119
Joined: Mon Jan 15, 2018 3:45 pm
Location: Tiel, The Netherlands
Has thanked: 30 times
Been thanked: 37 times

Mintypi v2 screen board (Helder) question

Post by Wailer » Wed Sep 19, 2018 6:55 am

When soldering my spi screen to helders board i noticed there was a very small gap between pin 9 and 10.
So when soldering the solder always bridges these two points together.
Is this a problem?
I found a pinout list that says 9 is vcc and 10 the led bl anode (both 3v) is this correct?
Hope someone can answer this.
20180919_144943.jpg
20180919_144943.jpg (2.98 MiB) Viewed 3456 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest