Page 1 of 1

Mintypi v2 screen board (Helder) question

Posted: Wed Sep 19, 2018 6:55 am
by Wailer
When soldering my spi screen to helders board i noticed there was a very small gap between pin 9 and 10.
So when soldering the solder always bridges these two points together.
Is this a problem?
I found a pinout list that says 9 is vcc and 10 the led bl anode (both 3v) is this correct?
Hope someone can answer this.
20180919_144943.jpg
20180919_144943.jpg (2.98 MiB) Viewed 7601 times