Stripped screws

Rakanel · Post by **Rakanel** » Wed Jun 19, 2019 7:26 pm

I have a stripped my faceplate screws. I have never worked with 3d printed parts before, so I thought the resistance was normal. Can anyone please help?

: image1.jpeg (2.79 MiB) Viewed 10636 times

Post by **LilTrublMakr** » Wed Jun 19, 2019 7:36 pm

Try taking a wide rubber band and put it in between the screw head and screwdriver. If that doesn't work, they do make kits that can remove stripped screws.

Rakanel · Post by **Rakanel** » Wed Jun 19, 2019 8:09 pm

LilTrublMakr wrote: ↑
Wed Jun 19, 2019 7:36 pm
Try taking a wide rubber band and put it in between the screw head and screwdriver. If that doesn't work, they do make kits that can remove stripped screws.

Thanks! I got them out by filing in a new groove and using a flathead!

On a side note. Am I able to run the minty pi without a better but plugged into the USB-C? It wont boot when I do, but it will boot from the USB port on the pi. The battery wont be here for a week or two

Rakanel · Post by **Rakanel** » Thu Jun 20, 2019 7:27 am

How do I mark this as solved?

Post by **LilTrublMakr** » Thu Jun 20, 2019 10:03 am

You wait until a mod moves it

Stripped screws

Stripped screws

Re: Stripped screws

Re: Stripped screws

Re: Stripped screws

Re: Stripped screws

Who is online