Page 2 of 2
Re: Fitting the Pi Zero into a custom printed cartridge
Posted: Tue Aug 23, 2016 8:58 pm
by NyteFury
I'm going to use at least part of the cart reader, and on the Pocket the fit is sooo tight with all the components and PCB button board that I don't think you could extend the cart into the case any length.
Re: Fitting the Pi Zero into a custom printed cartridge
Posted: Fri Sep 09, 2016 12:08 pm
by NyteFury
Got version 1.1 of the cart today. It still needs some work on the internals. Currently it's a little too tall to fit the in the gameboy, and there's not a hole for the SD card or HDMI port. Just wanted to let folks know there was progress and that it doesn't look as comical anymore.
[spoiler="version 1.1"]
[/spoiler]