I believe I've got my leveling down as when I do the live z calibration and it gets to the last "block", my bottom squishes well to form as one piece and the top of it looks very nice as well.
I did a benchy and that worked well (granted, I used a Cura and the official Prusa Cura profiles).
Now I'm using Slic3r PE and noticing some pretty crappy overhangs. At least at the lower levels near the bed.
The following pics are of the Terminator Rex print from Thingiverse. No supports and using the "Fine" default profile setting (0.1 layer height) and no changes to the profile settings.
Any advice on what I'm doing wrong or need to do to tweak? Specific instructions would be appreciated.
The Jaw print and most problematic print so far....
SpoilerShow
SpoilerShow