So I wanted to be able to use the Pro Controller for the Nintendo Switch, while in handheld mode. Instead of using the joy cons. I found this print on MyMiniFactory, was done by @JeremyDelisle. I will say it probably the only way I play the Switch now.
There's a few changes that I'm going to have done, with the help of my friend that's good with 3D Design. And also make it lighter.
Took about 13 hours to print all of it, on a Zortrax M200
Printed probably one of the best controller mounts for Nintendo Switch
- rodocop
- Posts: 1723
- Joined: Mon Aug 22, 2016 3:14 pm
- Location: Saskatchewan
- Has thanked: 606 times
- Been thanked: 608 times
Re: Printed probably one of the best controller mounts for Nintendo Switch
Yeah, that is one of my favorite prints as well, I prefer the pro controller over the joy cons any day.
SpoilerShow
_____________________________________________________
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
Re: Printed probably one of the best controller mounts for Nintendo Switch
No problem covering the intake for the fan?
Who is online
Users browsing this forum: No registered users and 1 guest