Making a hat for an M3D micro+
Posted: Mon Mar 04, 2019 3:19 pm
Not technically 3D printed but still in the same sphere.
I picked up the M3D micro+ because it doesn't take up much room and can sit in the corner ready when I need it. This is a filament holder that mounts it above the printer to keep the footprint small, it also holds a Raspberry Pi 3 with a touchscreen and octoprint + a camera that can be stored on the side.
I messed up and blocked the USB ports on the Pi so that needs a small redesign, and I need to print off some end caps for the copper pipe.
I picked up the M3D micro+ because it doesn't take up much room and can sit in the corner ready when I need it. This is a filament holder that mounts it above the printer to keep the footprint small, it also holds a Raspberry Pi 3 with a touchscreen and octoprint + a camera that can be stored on the side.
SpoilerShow
- IMG_7253 - Copy.JPG (1.21 MiB) Viewed 6137 times
- IMG_7257 - Copy.JPG (1.05 MiB) Viewed 6137 times
- IMG_7258 - Copy.JPG (1.03 MiB) Viewed 6137 times
- IMG_7259 - Copy.JPG (952.45 KiB) Viewed 6137 times
- IMG_7248 - Copy.JPG (1.34 MiB) Viewed 6137 times