Page 3 of 4
Re: Rear Button Bracket
Posted: Sun Jun 18, 2017 5:12 pm
by caste
atamagaokashii wrote: ↑Sat Jun 17, 2017 5:58 pm
Will this fit in the area underneath where it is shown in the pictures or might I need to trim?
It fit where I showed in the photos without any modifications to the case
Re: Rear Button Bracket
Posted: Mon Jul 31, 2017 5:33 am
by Xero
Just had this printed - fits nice and snug - perfect addition to my GBZ WIP.
Re: Rear Button Bracket
Posted: Mon Jul 31, 2017 7:09 am
by BadBert
@caste : Thanks a lot
i'll be using this in my new build (HDMI screen, no cart reader)
@starmagoo : you can easily make your own using the copper tape method that @Wermy uses on his first build guide, and you can even cut a bit from a original gameboy pcb if you have that lying around.
You can also use a bit of the same board wermy uses to make the power strip!!
Re: Rear Button Bracket
Posted: Mon Aug 21, 2017 5:40 pm
by Rettocs
Has anyone used this with Kite's SIAO board? If so, how did it turn out? Thanks in advance!
Re: Rear Button Bracket
Posted: Wed Sep 20, 2017 4:54 am
by Marc
Hi, did that stl model is in mm or inch ?
Thanks
Re: Rear Button Bracket
Posted: Wed Sep 20, 2017 6:12 am
by abrugsch
i printed one without changing any settings in mm
Re: Rear Button Bracket
Posted: Sat Sep 23, 2017 12:58 pm
by Rroobb21
hi all I'm just getting one of these printed through 3dhub and had this message back
" What did you model this in? This model seems to have some slicing errors. Is there any chance you could send it as a parasolid/step file?"
im not clued up any 3d printing so not sure what to do next any help would be great thanks
Re: Rear Button Bracket
Posted: Sat Sep 23, 2017 1:29 pm
by ICMF
Looks like there were a couple of errors created when the model was saved as a printable file. They're really easy to fix with a free application called Netfabb (kind of surprised the person printing your file isn't doing this anyway). I've uploaded the corrected version here; try sending them this one:
https://ufile.io/nz9lh
(Fair warning: link will expire in a month)
What's strange, though, is that from the posts above... obviously the original file has printed just fine. I just loaded it into Cura and I'm not getting any errors. I didn't notice any major issues scanning through the layers either. So what would be the problem now? Different slicer?
Re: Rear Button Bracket
Posted: Sun Sep 24, 2017 1:43 am
by Rroobb21
Brilliant thanks so much. I think its maybe the guy who's printing it. il try someone different for 3dhub
Re: Rear Button Bracket
Posted: Fri Nov 10, 2017 9:03 pm
by caste
Rettocs wrote: ↑Mon Aug 21, 2017 5:40 pm
Has anyone used this with Kite's SIAO board? If so, how did it turn out? Thanks in advance!
The build I designed this for used Kite's SAiO. Worked out great.