Glue Less Support Bracket for Kite's Mode/Power Switch Board

Share your STL files, CAD design files, etc. here!
jcarpfishman
Posts: 1
Joined: Tue Jul 10, 2018 7:38 pm

Re: Glue Less Support Bracket for Kite's Mode/Power Switch Board

Post by jcarpfishman » Tue Feb 26, 2019 11:59 pm

PM sent! :)

ThersiT
Posts: 1
Joined: Mon Jun 17, 2019 6:18 pm

Re: Glue Less Support Bracket for Kite's Mode/Power Switch Board

Post by ThersiT » Wed Jun 26, 2019 6:48 pm

Hi HoolyHoo, I don't have a 3d printer either, would you be willing to print up this part along with some of your other designs for me?

User avatar
HoolyHoo
Posts: 720
Joined: Sat Jul 09, 2016 9:34 pm
Has thanked: 200 times
Been thanked: 716 times

Re: Glue Less Support Bracket for Kite's Mode/Power Switch Board

Post by HoolyHoo » Wed Jun 26, 2019 9:03 pm

ThersiT wrote:
Wed Jun 26, 2019 6:48 pm
Hi HoolyHoo, I don't have a 3d printer either, would you be willing to print up this part along with some of your other designs for me?
Sure, send me a PM.

tlxxxsracer
Posts: 54
Joined: Thu Jul 28, 2016 8:54 am
Has thanked: 2 times
Been thanked: 2 times

Re: Glue Less Support Bracket for Kite's Mode/Power Switch Board

Post by tlxxxsracer » Thu Jul 04, 2019 4:43 pm

I had someone locally print this and doesnt seem to sit up against the mode button. Also sits higher so the button actually doesnt sit inside the hole of the DMG case.
What could be the issue?

User avatar
HoolyHoo
Posts: 720
Joined: Sat Jul 09, 2016 9:34 pm
Has thanked: 200 times
Been thanked: 716 times

Re: Glue Less Support Bracket for Kite's Mode/Power Switch Board

Post by HoolyHoo » Thu Jul 04, 2019 5:06 pm

tlxxxsracer wrote:
Thu Jul 04, 2019 4:43 pm
I had someone locally print this and doesnt seem to sit up against the mode button. Also sits higher so the button actually doesnt sit inside the hole of the DMG case.
What could be the issue?
You have to make sure you soldered the mode button at the right height to be even with the hole. I had to desolder my mode button on my build to get it right. I think kite sends the mode button unsoldered now for that reason I believe. Also did you print the additional little support that goes behind the button also? It gives the button support for when you press it.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest