sudomod

PM sent!

Hi HoolyHoo, I don't have a 3d printer either, would you be willing to print up this part along with some of your other designs for me?

ThersiT wrote: ↑

Wed Jun 26, 2019 6:48 pm

Hi HoolyHoo, I don't have a 3d printer either, would you be willing to print up this part along with some of your other designs for me?

Sure, send me a PM.

I had someone locally print this and doesnt seem to sit up against the mode button. Also sits higher so the button actually doesnt sit inside the hole of the DMG case.
What could be the issue?

tlxxxsracer wrote: ↑

Thu Jul 04, 2019 4:43 pm

I had someone locally print this and doesnt seem to sit up against the mode button. Also sits higher so the button actually doesnt sit inside the hole of the DMG case.
What could be the issue?

You have to make sure you soldered the mode button at the right height to be even with the hole. I had to desolder my mode button on my build to get it right. I think kite sends the mode button unsoldered now for that reason I believe. Also did you print the additional little support that goes behind the button also? It gives the button support for when you press it.

Would love to grab one of these but haven't been a member long enough to PM.

RTBoston wrote: ↑

Wed Apr 01, 2020 6:47 pm

Would love to grab one of these but haven't been a member long enough to PM.

You should be able to now.

HoolyHoo wrote: ↑

Thu Apr 02, 2020 9:35 am

RTBoston wrote: ↑

Wed Apr 01, 2020 6:47 pm

Would love to grab one of these but haven't been a member long enough to PM.

You should be able to now.

Sent. Much appreciated.

HoolyHoo wrote: ↑

Thu Feb 22, 2018 8:08 am

The solution to the later is to unsolder the mode button and replace it with similar one to where the stem is about 2mm longer.

Any more info on which size tactile switch I should buy for this?

mrdude42 wrote: ↑

Fri Jun 19, 2020 4:16 pm

HoolyHoo wrote: ↑

Thu Feb 22, 2018 8:08 am

The solution to the later is to unsolder the mode button and replace it with similar one to where the stem is about 2mm longer.

Any more info on which size tactile switch I should buy for this?

I don’t unfortunately. It’s been a while since I’ve built it. I had bought a variety pack that had an assortment of sizes and used the one that fit best. Never took notice as to the actual length.