Page 1 of 1

Pac-Man and Space Invaders Themed Rear Fan Holder

Posted: Thu May 23, 2019 9:06 am
by infinitLoop
I've been meaning to stick these up here, and the build I made them for has been in a holding pattern for a while, so here's just this bit if anyone might want to use these on their project...

I made these for a 3A+ build that I wanted to put a fan on, but thought I'd try to get a little creative with the fan's grill. I wanted to use the spots where you would normally put stickers for the serial number and what-not. The first one I did was the Space Invaders theme, but I wasn't happy with the fidelity of the print for the sprites, so I re-did it with pac-man, and I think that one came out better, given it's mostly a lot of dots anyway.

the fan I used was 30mm x 30mm x 7mm, like these. It fits tightly and the fan holds it in place, so glue isn't neccessary. There is a bit of a lip in the inside-pi-side of the model, to help keep wires and stuff from hitting the fan.
pacman_fan.png
pacman_fan.png (124.08 KiB) Viewed 6009 times
invaders_fan.png
invaders_fan.png (135.17 KiB) Viewed 6009 times
this is a finished print, but i had started sanding it down some to see if I could get a smooth finish, that i could coat with clear-coat, but I think it actually looked better un-sanded, with the print lines visible.
IMG_5361.jpg
IMG_5361.jpg (687.75 KiB) Viewed 6009 times
rear cut-outShow
IMG_5251.jpg
IMG_5251.jpg (810.87 KiB) Viewed 6009 times
inside with fanShow
IMG_5252.jpg
IMG_5252.jpg (696.63 KiB) Viewed 6009 times
with half-cut cartridgeShow
IMG_5253.jpg
IMG_5253.jpg (1.01 MiB) Viewed 6009 times

Re: Pac-Man and Space Invaders Themed Rear Fan Holder

Posted: Mon May 27, 2019 7:42 pm
by wermy
Awesome, thanks for sharing!