Looking for recommendations for a printer or printing software? Have a printer you recommend? Or one you strongly recommend *against*? Post it here!
3 posts • Page 1 of 1
I would assume that both ABS and PLA would work fine for the printing of parts for use in a MintyPi/GBZ/Similar projects, what is everyone using and is there any reason to use one type over the other for this sort of printing project.
- Site Admin
- Posts: 1283
- Joined: Tue May 03, 2016 8:51 pm
- Has thanked: 562 times
- Been thanked: 1270 times
Depending on what kind of printer you have, PLA can be much easier to print than ABS (so for the mintyPi for example, it's easier to get a nice flat faceplate with PLA rather than ABS usually). I use ABS for parts that need screws threaded into them as it's a little tougher. But honestly, as far as the actual characteristics of the materials go you're probably fine using either one.
- Posts: 128
- Joined: Sat May 20, 2017 3:06 am
- Location: Amsterdam, The Netherlands
- Has thanked: 42 times
- Been thanked: 36 times
https://www.3dhubs.com/knowledge-base/p ... difference
- ABS and PLA are the most common desktop FDM printed materials and are typically similar in cost. ABS has superior mechanical properties but is harder to print with compared to PLA.
- PLA is ideal for 3D prints where aesthetics are important. Due to its lower printing temperature is easier to print with and therefore better suited for parts with fine details.
- ABS is best suited for applications where strength, ductility, machinability and thermal stability are required. ABS is more prone to warping.
Who is online
Users browsing this forum: No registered users and 1 guest