sudomod

Excellent work wermy, I can't stress enough how much you've inspired me to get into electronics.

While I wait for the parts to arrive to give this one a try, I noticed I'm not sure how you put in the VMU connector . Do you happen to have some pictures on how you connected it to charge, rotate the screen and receive input from the controller?

Just waiting on PCBs from OSHPark now to get this one underway. Hoping they rock up today.

Was initially going to slice the original PCB as Wermy has done but then found these little numbers by smoki86:

https://oshpark.com/profiles/smoki86

Will be using the an original grey for this build and will post updates as I go

How can I SSH into it? it's hard to read the menus test to turn on wifi.... Love the work! Keep it up.

To SSH into your device, read here ——> https://sudomod.com/forum/viewtopic.php?t=3567

YaYa wrote: ↑

Sat Jun 23, 2018 2:24 pm

To SSH into your device, read here ——> https://sudomod.com/forum/viewtopic.php?t=3567

Thank you so much!!!!

Hey wermy,

I noticed on one of your IG pictures that the corners of a similar screen used for this project were shaved off a little bit (not sure if that one was used for this project or not)
I've been battling with making that same screen fit in the VMU. Did you used the x-acto knife or the Dremel to cut them out?

Thanks!

Hey just curious, what kind of wire did you guys use?

Mr.Modd wrote: ↑

Wed Oct 31, 2018 7:32 pm

Hey just curious, what kind of wire did you guys use?

Magnet wire for these or 30AWG silicone

Hey can you pls tell me how to connect the 1.44 inch display with the pi through the 10 wires(of the screen) you have depicted in the vmu project log while there were only 8 present in the image.

KINDLY HELP AS I AM NEW AT THIS. PLEASE HELP.

So I don't have a 3D printer but I found somewhere online (shapeways.com) to print the bracket you printed , only problem is I don't know the dimensions. Should it be fine to print just uploading the files?