Page 3 of 3

Re: VMµ - Sega Dreamcast VMU Project

Posted: Thu Jun 07, 2018 7:51 am
by smoscar01
Excellent work wermy, I can't stress enough how much you've inspired me to get into electronics.

While I wait for the parts to arrive to give this one a try, I noticed I'm not sure how you put in the VMU connector :D . Do you happen to have some pictures on how you connected it to charge, rotate the screen and receive input from the controller?

Re: VMµ - Sega Dreamcast VMU Project

Posted: Thu Jun 14, 2018 9:40 pm
by Lphillimore
Just waiting on PCBs from OSHPark now to get this one underway. Hoping they rock up today.

Was initially going to slice the original PCB as Wermy has done but then found these little numbers by smoki86:

https://oshpark.com/profiles/smoki86

Will be using the an original grey for this build and will post updates as I go :mrgreen:

Re: VMµ - Sega Dreamcast VMU Project

Posted: Sat Jun 23, 2018 2:06 pm
by ExProjects
How can I SSH into it? it's hard to read the menus test to turn on wifi.... Love the work! Keep it up.

Re: VMµ - Sega Dreamcast VMU Project

Posted: Sat Jun 23, 2018 2:24 pm
by YaYa
To SSH into your device, read here ——> https://sudomod.com/forum/viewtopic.php?t=3567

Re: VMµ - Sega Dreamcast VMU Project

Posted: Sat Jun 23, 2018 3:02 pm
by ExProjects
YaYa wrote:
Sat Jun 23, 2018 2:24 pm
To SSH into your device, read here ——> https://sudomod.com/forum/viewtopic.php?t=3567
Thank you so much!!!!

Re: VMµ - Sega Dreamcast VMU Project

Posted: Mon Aug 20, 2018 3:42 pm
by smoscar01
Hey wermy,

I noticed on one of your IG pictures that the corners of a similar screen used for this project were shaved off a little bit (not sure if that one was used for this project or not)
Cornerless ScreenShow
Image
I've been battling with making that same screen fit in the VMU. Did you used the x-acto knife or the Dremel to cut them out?

Thanks!

Re: VMµ - Sega Dreamcast VMU Project

Posted: Wed Oct 31, 2018 7:32 pm
by Mr.Modd
Hey just curious, what kind of wire did you guys use?

Re: VMµ - Sega Dreamcast VMU Project

Posted: Sun Nov 04, 2018 9:47 am
by KonnorJ
Mr.Modd wrote:
Wed Oct 31, 2018 7:32 pm
Hey just curious, what kind of wire did you guys use?
Magnet wire for these or 30AWG silicone