How to cut shells for the PocketPi FE?

Post Reply
Nikosaeder
Posts: 42
Joined: Thu Jan 31, 2019 3:42 am
Has thanked: 2 times
Been thanked: 10 times

How to cut shells for the PocketPi FE?

Post by Nikosaeder » Thu Jun 13, 2019 3:33 pm

I know there's a build video from wermy, but he had a few different parts iirc.

User avatar
KonnorJ
Posts: 376
Joined: Thu Jan 11, 2018 1:23 am
Location: United Kingdom
Has thanked: 56 times
Been thanked: 109 times
Contact:

Re: How to cut shells for the PocketPi FE?

Post by KonnorJ » Tue Aug 13, 2019 9:54 am

Use the pcb to create a mark for the button holes, use a drill bit to 9mm then a step bit to 9.5mm, carefully turning it by hand until the buttons are able to move freely in the holes, then use a dremel and/or pliers and craft knife to cut out most of the rear cart section, dremel away all of the battery bay apart from the screw holes. Cut the right side of the screen bezel slightly and you are done.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest