Page 1 of 1
How to cut shells for the PocketPi FE?
Posted: Thu Jun 13, 2019 3:33 pm
I know there's a build video from wermy, but he had a few different parts iirc.
Re: How to cut shells for the PocketPi FE?
Posted: Tue Aug 13, 2019 9:54 am
Use the pcb to create a mark for the button holes, use a drill bit to 9mm then a step bit to 9.5mm, carefully turning it by hand until the buttons are able to move freely in the holes, then use a dremel and/or pliers and craft knife to cut out most of the rear cart section, dremel away all of the battery bay apart from the screw holes. Cut the right side of the screen bezel slightly and you are done.