I have been a bit distracted with other stuff within the last couple of weeks. So tonight I decided to try to make a few adjustments and get a print going. After my last print I decided to to focus my efforts on getting the main part to fit in first then make holes for the tact switches. So what I did was pulled out the pieces from my last prints and made adjustments. On my V4 prints I broke off and marked problematic parts.
My next task were to make the right adjustments in blender, print, and test.
After making adjustments I have not been able to get a good print going, it seems like nothing is sticking to the bed. So I am basicly I am at a stand still until my new print surface arrives.
so here is v5 of my thing. They are just the blanks for now.
https://www.dropbox.com/s/d9flzz5i0xzuh ... 5.zip?dl=0