I have a problem that is driving me crazy.
I have soldered the Pi Zero to the SAIO board, and connect the MicroSD to the SAIO, the HDMI to the PI and the power directly to the PI.
In the Test Mode I see all FAILED (I suppose this is normal at this point), but I see the image on the monitor and it is reading the MicroSD card perfectly.
However, when soldering the 3.3V Jumper and connecting the power directly to the SAIO board, both the Pi and the SAIO are powered but I can not see anything on the monitor.
What can be wrong?
I attach an image of the board.
![Image](http://i68.tinypic.com/11uvord.jpg)
Thanks.