I just decided to use a Nintendo DS Joystick instead of a PSP one for the new CS board, since I found it more appeal in terms of style and layout.
I have seen that Kite used the exact same one for his assembly guide on the Super AIO (You can check it here):
)
Reading the assembly Guide for the CS board I notice the following "The joystick should be glued in well. 4pin JST cables are included that will wire up to the joystick solder points". The DS Joystick comes by default with a tiny ribbon connector instead of any exposed solder pins, so I don't really know how I can accomplish this.
![Image](https://images-na.ssl-images-amazon.com/images/I/41aLA1x-F9L._SY355_.jpg)
So my question is, How is possible to wire the DS Joystick to the board then?, How Kite's did it on the Super AIO version? Is there any adaptor that I can use?
Any light on this will be highly appreciated.
Thanks!