Help getting board down to 5v

Macromun · Post by **Macromun** » Sun Mar 25, 2018 5:05 pm

I recently got a screen for my GBZ project and it isn't a screen that isn't on the forum. This was a screen bought off Amazon, (https://www.amazon.com/gp/product/B0045 ... UTF8&psc=1) and due to the nature of taking a product apart, I probably won't get a refund. If anyone could help me with this, it would be much appreciated!

roxas232 · Post by **roxas232** » Tue Mar 27, 2018 9:03 pm

Jump the power (red wire) to pin 3 on the AM569
http://www.datasheetlib.com/datasheet/1 ... #datasheet
It may work better if you remove the chip, not sure though

Hex · Post by **Hex** » Wed Mar 28, 2018 1:51 pm

Another safer and sure shot method is to use the 3.3v pin of the pi to 3.3v pin of the board for power supply. GND to GND and TV to AV1. That should work just fine

Keyn · Post by **Keyn** » Mon Apr 09, 2018 6:41 am

I got this bw board and I don't know how I can make it to 5V.
I would be happy if somebody can help me

Thump52 · Post by **Thump52** » Mon Apr 09, 2018 8:12 am

Here you go, good luck with your build.

Keyn · Post by **Keyn** » Mon Apr 09, 2018 8:29 am

Thank you
And you only have to connect the yellow or the white wire to the raspberry or?

Thump52 · Post by **Thump52** » Mon Apr 09, 2018 11:31 am

Yes only one, I personally just use the yellow wire.

Keyn · Post by **Keyn** » Mon Apr 09, 2018 11:02 pm

Where did you got the screw bracket?

Help getting board down to 5v

Help getting board down to 5v

Re: Help getting board down to 5v

Re: Help getting board down to 5v

Re: Help getting board down to 5v

Re: Help getting board down to 5v

Re: Help getting board down to 5v

Re: Help getting board down to 5v

Re: Help getting board down to 5v

Who is online