Helder wrote: ↑Thu Dec 27, 2018 3:17 pm
The Camble PCB for the Powerboost should work since it has the enable pin but my board does not have the LBO pin which I think his board needs so might have to go with the bangood one then (not sure it's available anymore).
Yeah...
apparently its not available anymore....
i have both here....
I was hoping it would have been suitable with the power boost one, as that has been sitting here for nearly a year
worst case scenario...
i'm just gonna try to knock up my own (banggood)
the othermods site has a complete guide on how his safe shutdown and low battery is wired (IRF7319 & LM393)
(it might just need some slight adjusting for this)
Helder wrote: ↑Thu Dec 27, 2018 3:17 pm
The MintyPiBattery scripts have a folder with the icons as .png file you can edit WHILE it is not running so edit them as root or before you install the lines in the rc.local file.
Thanks
I'll give that a try....
.