Tools used for the build:
- Soldering Iron
- Flux paste
- Dremel
- Exacto knife
- Screwdriver
- Pliers
PCB & Pi
Performing initial suggested testsShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/19560552671551554012.png)
Soldering Pi to PCBShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/2284568761551554176.png)
Booting up for the first timeShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/2044637211551554395.png)
Shaving off the lidShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/18741544391551554400.png)
Getting the case readyShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/12877855101551554405.png)
Making room for L/R buttons and batteryShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/8663193581551554740.png)
Gluing L/R buttons in placeShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/16948251281551554735.png)
Sorting things outShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/20052054871551555196.png)
Closing the case 1Show
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/9841608161551555208.png)
Closing the case 2Show
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/2765843741551555219.png)
Playing something that requires L/R buttonsShow
![Image](https://ezway-imagestore.s3.amazonaws.com/files/2019/03/18203632991551555223.png)