Mintypi works great, but won't run off battery power.
Continuity is good all around -- but one of the pins in the PCB battery cable socket (6 pins, off-white) is bent. Probably the culprit?
Tried straightening it with a sewing needle, but no luck. I think I could replace the socket without trouble, if I knew what to order.
Bent pin in battery cable socket
-
- Posts: 2
- Joined: Sun Jul 14, 2019 8:12 am
- Been thanked: 1 time
-
- Posts: 2
- Joined: Sun Jul 14, 2019 8:12 am
- Been thanked: 1 time
Re: Bent pin in battery cable socket
Got in there with a mechanical pencil tip and straightened it out *just* enough. All good now!
Who is online
Users browsing this forum: No registered users and 1 guest