Responsiveness of ABXY Buttons
-
- Posts: 2
- Joined: Sun Aug 20, 2017 4:55 pm
- Has thanked: 1 time
Responsiveness of ABXY Buttons
So after about a month of working on this during the very little time I had on weekends I have finally finished my mintypi. The only problem I am having with it is that the A button only occasionally registers as being pressed and for it to register I need to press it very hard. All of the soldered GPIO holes give a constant beep so I’m not sure a way to make it better. Anyone with tips please reply!
Re: Responsiveness of ABXY Buttons
Please don't start an entire new thread, especially when there is one with the literal exact same problem as yours:
http://www.sudomod.com/forum/viewtopic.php?f=34&t=4152
Helder recommends to run a clean soldering tip over the pads, and remelt them. It hasn't been done yet, and I'm pretty busy this week, so just wait until someone else tries it.
http://www.sudomod.com/forum/viewtopic.php?f=34&t=4152
Helder recommends to run a clean soldering tip over the pads, and remelt them. It hasn't been done yet, and I'm pretty busy this week, so just wait until someone else tries it.
Who is online
Users browsing this forum: No registered users and 1 guest