Ant's Circuit Sword STL Files (joystick, shoulder button, exhaust fan cartridge)

Share your STL files, CAD design files, etc. here!
User avatar
andershp
Posts: 39
Joined: Fri Jan 25, 2019 9:25 am
Has thanked: 10 times
Been thanked: 5 times

Re: Ant's Circuit Sword STL Files (joystick, shoulder button, exhaust fan cartridge)

Post by andershp » Sun Sep 08, 2019 4:50 am

Had to bite off the outer part of the 3d-printed part and then it fit fine.
Board has to go on top, otherwise USB and analog volume control will be at an angle instead of parallel with the casing.
My "Bubble Bobble" Themed Bartop Arcade: https://retropie.org.uk/forum/topic/107 ... cade-build

User avatar
AntFJ
Posts: 146
Joined: Thu Nov 16, 2017 8:09 pm
Has thanked: 31 times
Been thanked: 99 times

Re: Ant's Circuit Sword STL Files (joystick, shoulder button, exhaust fan cartridge)

Post by AntFJ » Sun Sep 08, 2019 2:11 pm

I haven't ever seen the volume board version so I'm not sure why it didn't fit. glad you got it worked out.

For thread continuity the board normally goes over.
20181104_201147.jpg
20181104_201147.jpg (2.61 MiB) Viewed 353 times

TeeReQs
Posts: 36
Joined: Tue Sep 11, 2018 1:17 am
Has thanked: 12 times
Been thanked: 2 times

Re: Ant's Circuit Sword STL Files (joystick, shoulder button, exhaust fan cartridge)

Post by TeeReQs » Mon Sep 09, 2019 6:57 pm

Thanks for these files! I'm building a CS right now, and using your psp joystick holder. Did you use any glue or epoxy for it, or does the board hold it in place?

User avatar
AntFJ
Posts: 146
Joined: Thu Nov 16, 2017 8:09 pm
Has thanked: 31 times
Been thanked: 99 times

Re: Ant's Circuit Sword STL Files (joystick, shoulder button, exhaust fan cartridge)

Post by AntFJ » Mon Sep 09, 2019 8:03 pm

I would use a dab of hot glue to hold the bracket down and then use a toothpick to add epoxy to the edges. This is required for the joysticks or they could just pop out when playing
TeeReQs wrote:
Mon Sep 09, 2019 6:57 pm
Thanks for these files! I'm building a CS right now, and using your psp joystick holder. Did you use any glue or epoxy for it, or does the board hold it in place?

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests