CM3 Circuit Sword Fan Cartridge

Share your STL files, CAD design files, etc. here!
User avatar
HoolyHoo
Posts: 691
Joined: Sat Jul 09, 2016 9:34 pm
Has thanked: 196 times
Been thanked: 684 times

Re: CM3 Circuit Sword Fan Cartridge

Post by HoolyHoo » Sun Jul 01, 2018 8:21 pm

dasfool wrote:
Sun Jul 01, 2018 7:40 pm
One more question, what size screws are needed to mount the fan to the cartridge?
Honestly I don’t know. I used some from my spare screws bin. I can tell you that they are really tiny though :D

dasfool
Posts: 19
Joined: Sat Aug 05, 2017 9:33 pm
Has thanked: 4 times
Been thanked: 6 times

Re: CM3 Circuit Sword Fan Cartridge

Post by dasfool » Sun Jul 01, 2018 11:10 pm

Lol ok. Would you say they are something you may repair eyeglasses with?

User avatar
HoolyHoo
Posts: 691
Joined: Sat Jul 09, 2016 9:34 pm
Has thanked: 196 times
Been thanked: 684 times

Re: CM3 Circuit Sword Fan Cartridge

Post by HoolyHoo » Mon Jul 02, 2018 3:38 am

dasfool wrote:
Sun Jul 01, 2018 11:10 pm
Lol ok. Would you say they are something you may repair eyeglasses with?
Yes, very close to that.

dasfool
Posts: 19
Joined: Sat Aug 05, 2017 9:33 pm
Has thanked: 4 times
Been thanked: 6 times

Re: CM3 Circuit Sword Fan Cartridge

Post by dasfool » Fri Jul 06, 2018 8:19 pm

Your fan cartridge, fan, back button pcb and the heatsink included with Kite's Circuit Sword all fit without issue. The heatsink does touch the button pcb (I added kapton tape to the back button pcb to isolate it), but the fan doesn't go down as far so it's no problem, it doesn't touch anything.

Also, I bought this eyeglass repair kit and used the screws labled "Nose Pads Thin" from it to secure the fan to the cartridge. The screws aren't a perfect match but they worked well enough.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest