Filament question

Looking for recommendations for a printer or printing software? Have a printer you recommend? Or one you strongly recommend *against*? Post it here!
Post Reply
Posts: 47
Joined: Sat Nov 04, 2017 3:04 pm
Has thanked: 22 times
Been thanked: 8 times

Filament question

Post by MrErickson » Mon Apr 16, 2018 10:03 pm

I would assume that both ABS and PLA would work fine for the printing of parts for use in a MintyPi/GBZ/Similar projects, what is everyone using and is there any reason to use one type over the other for this sort of printing project.

User avatar
Site Admin
Posts: 1300
Joined: Tue May 03, 2016 8:51 pm
Has thanked: 578 times
Been thanked: 1280 times

Re: Filament question

Post by wermy » Tue Apr 17, 2018 9:58 am

Depending on what kind of printer you have, PLA can be much easier to print than ABS (so for the mintyPi for example, it's easier to get a nice flat faceplate with PLA rather than ABS usually). I use ABS for parts that need screws threaded into them as it's a little tougher. But honestly, as far as the actual characteristics of the materials go you're probably fine using either one. :)

Posts: 142
Joined: Sat May 20, 2017 3:06 am
Location: Amsterdam, The Netherlands
Has thanked: 44 times
Been thanked: 43 times

Re: Filament question

Post by snoek09 » Tue Apr 17, 2018 12:24 pm ... difference
  • ABS and PLA are the most common desktop FDM printed materials and are typically similar in cost. ABS has superior mechanical properties but is harder to print with compared to PLA.
  • PLA is ideal for 3D prints where aesthetics are important. Due to its lower printing temperature is easier to print with and therefore better suited for parts with fine details.
  • ABS is best suited for applications where strength, ductility, machinability and thermal stability are required. ABS is more prone to warping.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest