Hey everyone. Started building my first GBZ a few days ago, and am stuck on audio...everything is working as expected. I'm planning on creating a wiring diagram for my entire build once it's complete, and I'll share with the forums (you can never have too many!), but I can't get audio to work.
I'm using a generic PRS-TECH.com PCB board (only for controls), so I need to do everything outside from that.
The end goal for me is to wire up a few things for audio:
- Raspberry Pi Zero
8O 1W speaker
5 pin Potentiometer
PJ-325 Headphone Jack
For now, I'd like to know that just audio works, so I'm trying to wire up just the speaker. I've tried the following, but am not getting anything but noise/static out of the speaker:
The following is in my /boot/config.txt as the very last line:
I've searched all over, but can't find anything specific to the above setup...Suggestions or anything else I can look at?