Spooky Arduino Eyes

Arduino/Teensy software/code questions and discussion
Post Reply
bencrawf
Posts: 2
Joined: Tue Aug 15, 2017 9:07 pm

Spooky Arduino Eyes

Post by bencrawf » Thu Feb 21, 2019 3:12 pm

I have all the materials and the 3d printed parts done to make the spooky Arduino Halloween eyes. I am very much so a newb when it comes to Arduino and github. How do you go about setting the code up on the ItsyBitsy M0 Express from the github code put that was altered by wermy? I have Ran a couple of codes on the boards to make sure I had the software on my pc correct. I see that the uncanny eyes from Adafruit has a great run down and I follow it but would like to not have to alter as much code if wermy has already done a lot of the work. Thanks for any help and sorry if this is a silly question.

User avatar
wermy
Site Admin
Posts: 1340
Joined: Tue May 03, 2016 8:51 pm
Has thanked: 609 times
Been thanked: 1317 times
Contact:

Re: Spooky Arduino Eyes

Post by wermy » Fri Feb 22, 2019 9:37 am

Hi,
So you're able to run code examples, but not the code from my uncanny eyes fork? What errors are you getting?
ImageImageImageImage

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests