Circuit Gem buttons problem!

Post Reply
Darth Mika
Posts: 5
Joined: Wed Nov 09, 2016 8:45 am
Has thanked: 2 times

Circuit Gem buttons problem!

Post by Darth Mika » Thu Jul 11, 2019 2:16 am

I am just an amateur in these raspberry pi programming. Yesterday I finished my own VMU gaming machine, but I was disappointed with those buttons. I would like to change those rubber buttons to pcb tactile switches.

For example, like that
https://www.distrelec.ch/en/tactile-swi ... p/13565645

Now I ask how to make these work in Circuit gem. I saw on your GPIO map ... there is BTN MODE - X, BTN SLEEP ZA, BTN A - ZF and U - BTN B. For example, if I put Tactile Switches to Mode, put one of the wire in that BTN MODE - X , but where I put the other wire.

Could you tell me this with the help of pictures ... make it easier to understand more.

I'm sorry for the bad English ... I hope you understand what I mean.

User avatar
kite
Posts: 852
Joined: Thu May 12, 2016 4:30 am
Location: UK
Has thanked: 223 times
Been thanked: 286 times
Contact:

Re: Circuit Gem buttons problem!

Post by kite » Thu Jul 11, 2019 3:47 am

The other side of the button needs to go to GND, which is any GND point on the board :)

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests