Page 1 of 1
BW TFT Driver Board Damage
Posted: Thu Jul 27, 2017 3:11 pm
by Arkies
Hey all
I've just started up my GBZ project and I got a little overzealous and popped a capacitor and another component off the driver board for the TFT screen. I was wondering if I would be able to solder the components back on and pretend like nothing happened.
Here are the ones I popped off. The black one marked 101 looks like a spool of tiny copper wire.
- BW_V9_Board.jpg (3.56 MiB) Viewed 5538 times
Any hope?
Re: BW TFT Driver Board Damage
Posted: Tue Aug 01, 2017 9:09 am
by tinkerBOY
Yes sure as long as no damage to those cap & inductor, you solder them back. How did you pop those components off?
Re: BW TFT Driver Board Damage
Posted: Tue Aug 01, 2017 9:39 am
by Arkies
zeroboy wrote: ↑Tue Aug 01, 2017 9:09 am
Yes sure as long as no damage to those cap & inductor, you solder them back. How did you pop those components off?
I didn't see the other screw so i twisted the back of the case, but I did it a little too hard and the bits came off, haha. Thank you for the info! the inductor was damaged but we know the code on it, think I could buy a 101 inductor from amazon and slap it on there?
Re: BW TFT Driver Board Damage
Posted: Tue Aug 01, 2017 9:43 am
by tinkerBOY
Arkies wrote: ↑Tue Aug 01, 2017 9:39 am
zeroboy wrote: ↑Tue Aug 01, 2017 9:09 am
Yes sure as long as no damage to those cap & inductor, you solder them back. How did you pop those components off?
I didn't see the other screw so i twisted the back of the case, but I did it a little too hard and the bits came off, haha. Thank you for the info! the inductor was damaged but we know the code on it, think I could buy a 101 inductor from amazon and slap it on there?
Yes just make sure it's a 101 inductor.
Re: BW TFT Driver Board Damage
Posted: Tue Aug 01, 2017 10:09 am
by Arkies
zeroboy wrote: ↑Tue Aug 01, 2017 9:43 am
Arkies wrote: ↑Tue Aug 01, 2017 9:39 am
zeroboy wrote: ↑Tue Aug 01, 2017 9:09 am
Yes sure as long as no damage to those cap & inductor, you solder them back. How did you pop those components off?
I didn't see the other screw so i twisted the back of the case, but I did it a little too hard and the bits came off, haha. Thank you for the info! the inductor was damaged but we know the code on it, think I could buy a 101 inductor from amazon and slap it on there?
Yes just make sure it's a 101 inductor.
sweet thank you again!
Re: BW TFT Driver Board Damage
Posted: Thu Aug 17, 2017 10:22 pm
by NSultana
You should be able to wire a new one on, just make sure you get the polarity correct.
