All in One PCB Support Thread

[Mischief]

Could the bellow thread be a potential fix for the AIO usb hub issues? Just a thought

http://www.sudomod.com/forum/viewtopic.php?f=8&t=1345

[dobebrief]

Total newbie here...

I just wired everything up. Got the screen working. It gets all the way to gamepad detected... and then when i try and push a button it just resets itself. Can add photos later. Would really appreciate any help i can get.

thanks,

dobebrief

[msykos]

Would look at the white wire on pp23, it goes to the AIO for usb control. The pad to the right of that one is very close and it is easy to solder those two together.

[Ganreizu]

@helder: So I tried dremeling a second board and wired it up, same no start button issue. Wired up a clean board and, of course, the start button works hahahaha. Big speaker definitely not worth.

[Helder]

It can be fixed with a jumper wire though, bring it by my house sometime and I'll fix it.

[Jdtreats]

Just to close the loop on my particular issue for future searchers...

I had to reload the drivers from the arduino/drivers folder for the board. After that it saw the AIO as a Leonardo again and it saw the PCB as a gamepad. Basically followed the first half of this procedure, up to (but not including) the programming step. I did wire in the tact switch but didnt end up needing it as I didnt have to reflash anything. http://www.sudomod.com/forum/viewtopic.php?f=25&t=1176

Now, this fixed the gamepad not being recognized, but I still dont have a functioning hub even after doing the v1.1 fix.
For now, i just wired in a DPDT switch to the Pi Zero and external USB/AIO board so I can at least proceed with the build to work on the audio.

Thanks

[Ganreizu]

It can be fixed with a jumper wire though, bring it by my house sometime and I'll fix it.

From the hole to the pin yeah? I had thought before going to bed haha but not too confident in doing it myself. That would be great since I'm doing more builds before christmas and don't want parts to go to waste.

[biokenx]

hello, I have the pbc 2.0 gamepad works as the doors usb not, the wires are connected according to the scheme and the power in USB port to connect directly to Powerboot 1000c. The old pbc from the photos I see that he had "usb from more" where you also connected the power supply, in 2.0 there is, I have to connect power from Powerboot qaulsiasi to a USB port on the pbc? sorry for my english but I'm Sicilian!

[bassholio]

Hey got my v2.2 board and the controls are working perfectly. Thank you!

Question: can I use a pi 3 and use the pwm0 audio output using the same config.txt modifications and use the same gpio pin? I tried the pi zero method with no luck. Thanks in advance.

[Helder]

Hey got my v2.2 board and the controls are working perfectly. Thank you!

Question: can I use a pi 3 and use the pwm0 audio output using the same config.txt modifications and use the same gpio pin? I tried the pi zero method with no luck. Thanks in advance.

I'm sure you can but doesn't the Pi3 already have proper audio output on the headphone socket?