Hello everyone, I have some problems with my gameboy.
Last weekend I've finally assembled all parts and soldered pi to cartridge reader and aio board. First problem I faced was USB - retropie couldn't start when something (a simple keyboard in my case) is connected. Okay, I resoldered all USB wires and the problem is gone (in general).
But for now I can see the whole spectre of problems, from time to time:
1. Can't press A/B/X/Y buttons to configure them as gamepad buttons - but they work perfectly when I pressed any of them to detect AIO board for retropie.
2. Sometimes all buttons can be configured in the right way, but when I open retropie menu and press down button once or twice to go to raspi-config or even configuration editor section - Emulationstation reboots.
3. Again, when two other problems don't appear and I'm able to open setting page (to enter wifi pass, for example), the selector at the bottom row (where OK, Back, Finish are located) is jumping between all buttons and cannot be controlled with d-pad or keyboard.
What did I do wrong? Is it a general problem with retropie (i'm using 4.3) or with my wiring?