BW Innolux screen variant

aiiaiiiyo · Post by **aiiaiiiyo** » Sun Aug 26, 2018 2:06 am

It seems like somewhere along the way I ruined the left part of my ribbon cable. Can someone guide me where should I connect this part?

https://imgur.com/gallery/vcoxjak

aiiaiiiyo · Post by **aiiaiiiyo** » Sun Aug 26, 2018 11:07 am

I tried out the screen and it doesnt seem to be affecting anything at all. Screen functioning as it should.

Post by **Helder** » Sun Aug 26, 2018 2:59 pm

Might be touch screen related.

aiiaiiiyo · Post by **aiiaiiiyo** » Mon Aug 27, 2018 4:08 am

Found the data sheet for the screen:
http://www.bdtic.com/datasheet/Innolux/PT035TN01-V6.pdf

It seems to be:

52 NC - No connect
53 VGH I Positive power for scan driver
54 NC - No connect
55 NC - No connect

Based on that maybe it has some effect when the picture is changing fast? However at the moment I'm not able to test that. The boot sequence with the console scrolling seemed ok to me. On other pictures from the same screen it is basically just connected to the side bracket of the screen. Fingers crossed.

BW Innolux screen variant

BW Innolux screen variant

Re: BW Innolux screen variant

Re: BW Innolux screen variant

Re: BW Innolux screen variant

Who is online