GBA-xl, A custom 3D printed Gameboy Advance

Want to show off your own project? Want to keep a build log of it? Post it here!
User avatar
dbak85
Posts: 40
Joined: Thu Mar 09, 2017 2:04 am
Has thanked: 14 times
Been thanked: 19 times

Progress has been made!

Post by dbak85 » Thu Oct 26, 2017 3:47 am

So I finally got my printer dialled in and working correctly.
I got my new 40a power supply (which is double the original, it hardly gets hot now).
Freshly printedShow
Image
Looking goodShow
Image
It took almost 7 hours but it is a pretty good result and very solid. I will start cleaning it and printing the rest of the parts this weekend

Raysplace30
Posts: 5
Joined: Thu Aug 03, 2017 8:40 am
Has thanked: 8 times
Been thanked: 1 time

Re: GBA-xl, A custom 3D printed Gameboy Advance

Post by Raysplace30 » Mon Oct 30, 2017 9:14 pm

Nice work - yeah I had to change the power supply on my a6 as well to print abs. Also found I had to solder to the heat bed rather than use the connect provided as it was rated too low.

dandelion
Posts: 4
Joined: Sat Jun 22, 2019 8:14 am
Been thanked: 1 time

Re: GBA-xl, A custom 3D printed Gameboy Advance

Post by dandelion » Wed Jul 31, 2019 5:57 am

Hi! I don’t know if this is still relevant to you. I just want to share my experience with you, maybe it will help someone to choose a fit 3D printer…

I just bought an A6 and so far am quite pleased with it. Looking at the photos of the A8, it looks like the A6 has a sturdier frame. If you want to see all the differences just look at the spec sheets for the two on AliExpress or Ebay. The A6 is a little larger than a standard i3, about 220mm x 220mm x 240mm.

It took about 5 hours to build the A6 following the tutorial on Youtube. So far I have been using it with Cura (the slicer software) and I have done about 10 prints – it’s my first printer so I can’t make any comparisons, but it appears to be solid and well specked.

I’m still in the experimental stage, but I have made one small modification. The Y-axis idle pulley was not turning, so I put small washers either side of the supports so that it can turn without touching the sides.

If you want to know more about how to choose the 3d printer and make the right decision, I will recommend reading this article.

https://top3dshop.com/blog/3d-printer-buying-guide

It was very helpful to me.

Good luck with your choice!

Post Reply

Who is online

Users browsing this forum: LabreaReloc and 1 guest