Circuit Sword Stealth Black

[banjokazooie]

Standard Circuit sword build in black transparent case with modified 3d printed parts.

[makazatra]

Very clean build!
Did you hotglue the screen bracket?

[banjokazooie]

Very clean build!
Did you hotglue the screen bracket?

No hot glue only transparent epoxy

[arbinshire]

I'm curious about the battery hookup. How is that done?

[TeeReQs]

Always clean builds! Really like the screen bracket. Thanks for uploading the files

[Jfenton78]

Nice work. Can you explain the button and D-pad spacers? Did you find the button/pad a little loose and was button spacer used on all 4 or just x and y? Was the top LCD bracket glued to the LCD? Thanks.

[banjokazooie]

Nice work. Can you explain the button and D-pad spacers? Did you find the button/pad a little loose and was button spacer used on all 4 or just x and y? Was the top LCD bracket glued to the LCD? Thanks.

Spacer for X and Y is needed as screen bracket sits on small edge of the front cover. D-pad spacer is there to prevent it to rattle. The top lcd bracket is glued to the sides of front cover only.

[linuxgb]

Standard Circuit sword build in black transparent case with modified 3d printed parts.

very nice buid
how is the top left 3d part use for ?
can you upload more pic for it ?
many thx

[AntFJ]

I like it! what joystick is that?

[MrErickson]

Looks good, I printed the top and bottom screen brackets out to have a look at them, I have another Circuit Sword coming, maybe I'll give these a shot. Thanks for sharing.