Emulator set up

[sandog]

So I have my sword up and going with rpi-4.4-rpi2_rpi3-wifi_CSO_CM3_20190131-213239.img. What do I need to get my emulators loaded and working? Can I use parts of another setup? I tried to do a search but couldnt find clear answer.

[McGyver]

You need to add roms. Google for it or search the forum.

[gizmo]

I'm at a similar stage with my original version of kite's aio.

However, I think the OP might be wanting to know what I am too.. and that is how do you actually get roms onto the device? What's got me confused is that when I put my sd card into my pc to transfer roms over I see no retropie folder?? Nor config, bios etc that I would normally expect to find? Could someone explain why this is?

[LilTrublMakr]

However, I think the OP might be wanting to know what I am too.. and that is how do you actually get roms onto the device? What's got me confused is that when I put my sd card into my pc to transfer roms over I see no retropie folder?? Nor config, bios etc that I would normally expect to find? Could someone explain why this is?

that confuses me too.

There's a link in my signature that explains how to add ROMs to the mintyPi. The same premise applies to pretty much any RetroPie powered device though there may be small differences.

[gizmo]

Thanks for that @LilTrublMakr that's an excellent guide.

Another way I use now is to type the ip address into a file explorer like this \\00.00.00.00 etc.

[LilTrublMakr]

Yeah, that is one way to do it but that also assumes that all devices are on the same network, workgroup, samba is set up, and a few other things. Just easier to give the way that will work for most people.